Because I needed to document my Vlan setup, of course. Serial cable swapped between an OPNsense firewall and a Fedora box. Verified that I don’t have to set Vlans on the host ports to hand out multiple DHCP domains. It does hog switch ports, tho.
This should better re-use than zip ties
I use the Presta adapter frequently.
This used table saw is definitely an improvement. However, it lacks sled grooves and a riving knife. I miss the sled grooves already. I think i should make a sled based on the fence.
Used 10 in table saw
This is absolutely typical of digital interactives.
This saw could be better. This sled could be better. It needs a wedge to square it up.
It took me a few tries to figure out how to use get the bungies around these pizzas. Bungies were too big, but not if I took up the slack by placing the pizzas atop to bungies and wrapped them around the top.
This is a Digium card, clearly intended for a 1U or ATX case. One of my goals is to reduce the number of high speed fans in the lab, so I repurposed my Lanner chassis. Using a typical twist drill bit is a poor choice for the job of an end mill, but it came out ok when I put a rotary steel brush to the aluminum plate.